Home › BODY ELECTRICAL › METER › LIGHT CONTROL RHEOSTAT

LIGHT CONTROL RHEOSTAT > INSPECTION

for Preparation Click here



1. INSPECT LIGHT CONTROL RHEOSTAT
  1. Disconnect the connector from the light control rheostat.



    E152418E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D4-1 (E) - D4-3 (RV)
    Turn the light control rheostat knob fully downwards
    Below 1 Ω
    D4-1 (E) - D4-3 (RV)
    Turn the light control rheostat knob downwards to upwards
    The value changes gradually (Between 1 to 8 kΩ)
    D4-1 (E) - D4-3 (RV)
    Turn the light control rheostat knob fully upwards
    8 to 12 kΩ
    D4-5 (TC) - D4-7 (T)
    Turn the light control rheostat knob fully upwards (Tail cancel ON)
    8 kΩ or higher
    D4-5 (TC) - D4-7 (T)
    Turn the light control rheostat knob fully downwards
    Below 1 Ω

    HINT:
    If the value is not as specified, replace the light control rheostat (Click here).