Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

DTC    5C-40    Camera Picture Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
5C-40
Synchronous signals from the camera cannot be transmitted.
  1. Wire harness
  2. Television camera assembly
  3. Navigation receiver assembly

WIRING DIAGRAM


E150790E04


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - TELEVISION CAMERA)


    E141024E07
  1. Disconnect navigation receiver assembly connector E4.



    E150736E03
  1. Disconnect television camera connector S1.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E4-24 (CA+) - S1-4 (CB+)
    Always
    Below 1 Ω
    E4-21 (CGND) - S1-3 (CGND)
    Below 1 Ω
    E4-22 (V+) - S1-2 (CV+)
    Below 1 Ω
    E4-23 (V-) - S1-1 (CV-)
    Below 1 Ω
    E4-24 (CA+) - Body ground
    10 kΩ or higher
    E4-21 (CGND) - Body ground
    10 kΩ or higher
    E4-22 (V+) - Body ground
    10 kΩ or higher
    E4-23 (V-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E153726E05
  1. Reconnect navigation receiver assembly connector E4.

  1. Measure the voltage of the camera.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E4-24 (CA+) - E4-21 (CGND)
    Power switch on (IG), shift lever in reverse position
    5.5 to 7 V



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


3.INSPECT TELEVISION CAMERA ASSEMBLY

E150777E01

  1. Reconnect television camera connector S1.

  1. Check the waveform of the television camera using an oscilloscope.

    OK:
    Waveform is as shown in the illustration.

    Item
    Content
    Terminal No. (Symbols)
    S1-2 (CV+) - S1-1 (CV-)
    Tool
    0.2 V/DIV., 0.2 μsec./DIV.
    Condition
    Power switch on (IG), shift lever in reverse position



NG
REPLACE TELEVISION CAMERA ASSEMBLY (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)