Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › ELECTRIC INVERTER COMPRESSOR

ELECTRIC INVERTER COMPRESSOR > INSPECTION

for Preparation Click here



1. INSPECT ELECTRIC INVERTER COMPRESSOR


    E109283E08
  1. Disconnect the connector from the electric inverter compressor (i1).

  1. Using a megohmmeter tester, measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    Condition
    Specified condition
    i1-1 (-) - Body ground
    Always
    2 MΩ or higher
    i1-2 (+) - Body ground
    Always
    2 MΩ or higher