Home › BODY › SLIDING ROOF › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > DISASSEMBLY

for Preparation Click here



1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    B173670
  1. Remove the 2 bolts and sliding roof drive gear sub-assembly.



2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY


    B160460
  1. Remove the screw and sliding roof piece sub-assembly LH.

    HINT:
    Use the same procedure for the RH side and the LH side.



    B152946
  1. Slide and remove the sunshade trim sub-assembly.



3. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

NOTICE:
Disassemble the sliding roof drive cable sub-assembly only when replacing it.



    B173672
  1. Remove the screw and sliding roof side stopper.

    HINT:
    Use the same procedure for the RH side and the LH side.



    B160476E01
  1. Using a screwdriver, disengage the 2 claws. Then slide the sliding roof drip channel rearward to remove it.

    HINT:
    Tape the screwdriver tip before use.



  1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.


    B160477E01