DTC B1411/11 Room Temperature Sensor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1411/11 | Open or short in room temperature sensor circuit |
|

| 1.INSPECT ROOM TEMPERATURE SENSOR |
![]() |
Remove the room temperature sensor (for front) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D26-1 (+) - D26-2 (-) | 10°C (50°F) | 3.00 to 3.73 kΩ |
| D26-1 (+) - D26-2 (-) | 15°C (59°F) | 2.45 to 2.88 kΩ |
| D26-1 (+) - D26-2 (-) | 20°C (68°F) | 1.95 to 2.30 kΩ |
| D26-1 (+) - D26-2 (-) | 25°C (77°F) | 1.60 to 1.80 kΩ |
| D26-1 (+) - D26-2 (-) | 30°C (86°F) | 1.28 to 1.47 kΩ |
| D26-1 (+) - D26-2 (-) | 35°C (95°F) | 1.00 to 1.22 kΩ |
| D26-1 (+) - D26-2 (-) | 40°C (104°F) | 0.80 to 1.00 kΩ |
| D26-1 (+) - D26-2 (-) | 45°C (113°F) | 0.65 to 0.85 kΩ |
| D26-1 (+) - D26-2 (-) | 50°C (122°F) | 0.50 to 0.70 kΩ |
| D26-1 (+) - D26-2 (-) | 55°C (131°F) | 0.44 to 0.60 kΩ |
| D26-1 (+) - D26-2 (-) | 60°C (140°F) | 0.36 to 0.50 kΩ |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ROOM TEMPERATURE SENSOR - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the D26 sensor connector.
Disconnect the D37 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D26-1 (+) - D37-29 (TR) | Always | Below 1 Ω |
| D26-2 (-) - D37-35 (SG-4) | Always | Below 1 Ω |
| D26-1 (+) - Body ground | Always | 1 MΩ or higher |
| D26-2 (-) - Body ground | Always | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||