DTC B1421/21 Solar Sensor Circuit (Passenger Side) |

| DTC No. | DTC Detection Condition | Trouble Area |
| B1421/21 | Open or short in passenger side solar sensor circuit |
|

| 1.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the power switch on (IG) and turn the Techstream main switch on.
Select the item below in the Data List, and read the value displayed on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Solar Sensor(P Side) | Passenger side solar sensor / Min.: 0, Max.: 255 | Passenger side solar sensor value increases as brightness increases | - |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to PROBLEM SYMPTOMS TABLE) | B |
| OK (When troubleshooting according to DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK SOLAR SENSOR (SENSOR POWER INPUT) |
![]() |
Disconnect the F1 solar sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F1-6 (CLTB) - F1-3 (CLTE) | Power switch off | Below 1 V |
| F1-6 (CLTB) - F1-3 (CLTE) | Power switch on (IG) | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK SOLAR SENSOR |
![]() |
Remove the solar sensor .
Connect a battery positive (+) lead to terminal 6 (CLTB) and a negative (-) lead to terminal 3 (CLTE) of the solar sensor.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F1-2 (TSR) - F1-3 (CLTE) | Sensor is subjected to electric light | 0.8 to 4.3 V |
| F1-2 (TSR) - F1-3 (CLTE) | Sensor is covered with a cloth | Below 0.8 V |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SOLAR SENSOR - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the F1 solar sensor connector.
Disconnect the D37 air conditioning amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D37-32 (TSP) - F1-2 (TSR) | Always | Below 1 Ω |
| D37-32 (TSP) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SOLAR SENSOR) |
![]() |
Disconnect the D7 main body ECU connector.
Disconnect the F1 solar sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D7-20 (CLTB) - F1-6 (CLTB) | Always | Below 1 Ω |
| D7-18 (CLTE) - F1-3 (CLTE) | Always | Below 1 Ω |
| D7-20 (CLTB) - Body ground | Always | 10 kΩ or higher |
| D7-18 (CLTE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||