Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

DTC    B1497/97    BUS IC Communication Malfunction

for Preparation Click here


DESCRIPTION

The air conditioning harness connects the air conditioning amplifier and the servos. The air conditioning amplifier supplies power and sends operation instructions to each servo through a communication / driver IC and wiring assembly called the air conditioning harness. Each servo sends damper position information to the air conditioning amplifier.

DTC No.
DTC Detection Condition
Trouble Area
B1497/97
Communication line error or open
  1. Air conditioning harness
  2. Air conditioning amplifier

WIRING DIAGRAM


E142541E05


INSPECTION PROCEDURE

1.CHECK AIR CONDITIONING AMPLIFIER


    E127567E16
  1. Remove the air conditioning amplifier (Click here) with its connectors still connected.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    z17-2 (BUS G) - Body ground
    Always
    Below 1 Ω



NG
CHECK GROUND LINE AND AIR CONDITIONING AMPLIFIER
OK


2.CHECK AIR CONDITIONING AMPLIFIER


    E127567E22
  1. Remove the air conditioning amplifier (Click here) with its connectors still connected.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    z17-2 (BUS G) - z17-4 (B BUS)
    Power switch on (IG)
    11 to 14 V
    z17-2 (BUS G) - z17-3 (BUS)
    Power switch on (IG)
    Pulse generation



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

REPLACE AIR CONDITIONING HARNESS ASSEMBLY