Home › BODY › WINDSHIELD / WINDOWGLASS › DEFOGGER RELAY

DEFOGGER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT DEFOGGER RELAY
  1. Remove the defogger relay from the engine room relay block.



    B177582E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Voltage is not applied between terminals 1 and 2
    Below 1 Ω
    3 - 4
    Apply battery voltage between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Apply battery voltage between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the defogger relay.