FRONT COOLING UNIT > DISASSEMBLY |
| 1. REMOVE ID CODE BOX (IMMOBILISER CODE ECU) |
![]() |
Disengage the 3 claws and remove the ID code box (Immobiliser Code ECU) as shown in the illustration.
| 2. REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY |
![]() |
Disengage the 3 claws and remove the No. 3 air duct sub-assembly as shown in the illustration.
| 3. REMOVE BLOWER ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 2 screws.
Disengage the 2 claws and remove the blower assembly.
| 4. REMOVE FRONT AIR OUTLET CONTROL SERVO MOTOR SUB-ASSEMBLY |
![]() |
Disconnect the 2 connectors.
Remove the 3 screws and the front air outlet control servo motor sub-assembly.
| 5. REMOVE FRONT AIR MIX CONTROL SERVO MOTOR SUB-ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 2 screws and front air mix control servo motor sub-assembly.
| 6. REMOVE HEATER CLAMP |
![]() |
Remove the screw and the clamp.
Disengage the 3 claws and remove the heater clamp.
| 7. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY |
![]() |
Remove the heater radiator unit sub-assembly as shown in the illustration.
| 8. REMOVE ASPIRATOR |
![]() |
Disengage the clamp.
Disengage the 2 claws and remove the aspirator.
| 9. REMOVE COOLER EXPANSION VALVE |
![]() |
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and cooler expansion valve.
| 10. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 6 screws.
Disengage the 5 claws and remove the plate cover.
![]() |
Disengage the clamp and remove the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor.
![]() |
Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.
| 11. REMOVE NO. 1 COOLER THERMISTOR |
![]() |
Remove the No. 1 cooler thermistor.