FRONT AXLE HUB > REMOVAL |
| 1. REMOVE FRONT WHEEL |
| 2. REMOVE FRONT AXLE HUB NUT |
![]() |
Using SST and a hammer, release the staked part of the front axle shaft nut LH.
While applying the brakes, remove the front axle shaft nut LH.
| 3. SEPARATE FRONT SPEED SENSOR |
![]() |
Remove the bolt and resin clamp, and separate the front speed sensor.
| 4. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the 2 bolts and separate the front disc brake caliper assembly.
| 5. REMOVE FRONT DISC |
![]() |
Remove the front disc.
| 6. SEPARATE TIE ROD ASSEMBLY |
Remove the cotter pin and the nut.
![]() |
Install SST to the tie rod end.
Using SST, separate the tie rod end from the steering knuckle.

| 7. SEPARATE FRONT LOWER SUSPENSION ARM |
![]() |
Remove the bolt and 2 nuts, and separate the front lower suspension arm from the front lower ball joint.
| 8. SEPARATE FRONT DRIVE SHAFT ASSEMBLY |
![]() |
Put matchmarks on the front drive shaft assembly and the front axle hub sub-assembly.
![]() |
Using a plastic hammer, separate the front drive shaft assembly from the front axle assembly.
| 9. REMOVE FRONT AXLE ASSEMBLY |
![]() |
Remove the 2 bolts, 2 nuts and front axle assembly.
| 10. REMOVE FRONT LOWER BALL JOINT |
![]() |
Secure the front axle assembly in a vise using aluminum plates.
![]() |
Remove the cotter pin and nut.
![]() |
Install SST to the front lower ball joint as shown in the illustration.
![]() |
Using SST, remove the front lower ball joint from the front axle assembly as shown in the illustration.
| 11. REMOVE NO. 1 FRONT WHEEL BEARING DUST DEFLECTOR |
![]() |
Using a screwdriver with its tip wrapped with vinyl tape, remove the No. 1 front wheel bearing dust deflector.
| 12. REMOVE FRONT AXLE HUB HOLE SNAP RING |
![]() |
Using snap ring pliers, remove the front axle hub hole snap ring.
| 13. REMOVE FRONT AXLE HUB SUB-ASSEMBLY |
Hold the front axle assembly between aluminium plates in a vise.
![]() |
Using SST, remove the front axle hub sub-assembly.
![]() |
Using SST and a press, remove the bearing inner race (outside) from the front axle hub sub-assembly.
| 14. REMOVE FRONT DISC BRAKE DUST COVER |
![]() |
Remove the 4 bolts and front disc brake dust cover from the steering knuckle.
| 15. REMOVE FRONT AXLE HUB BEARING |
Place the bearing inner race (outside) on the front axle hub bearing.
![]() |
Using SST, V-blocks and a press, remove the front axle hub bearing from the steering knuckle.