WINDSHIELD DEICER RELAY > ON-VEHICLE INSPECTION |
| 1. INSPECT WINDSHIELD DEICER RELAY (Marking: DEICER) |
![]() |
Measure the resistance of the relay. Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Apply battery voltage between terminals 1 and 2 | Below 1 Ω |