Home › ENGINE › 3MZ-FE STARTING › SMART KEY SYSTEM

DTC    B2271    Ignition Hold Monitor Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when a problem such as an open in the AM2 fuse, an open or short in the wire harness between the fuse and main body ECU (instrument panel junction block), a short in the IG output circuit inside the main body ECU (instrument panel junction block), a short between the main body ECU (instrument panel junction block) and relay, and a short in the relay is detected.

HINT:
When the main body ECU (instrument panel junction block) is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU (instrument panel junction block) is replaced, perform the registration procedures for the engine immobiliser system (Click here).


DTC No.
DTC Detection Condition
Trouble Area
B2271
Hold circuit, IG1 relay actuation circuit or IG2 relay actuation circuit inside main body ECU (instrument panel junction block) is open or shorted
  1. AM2 fuse
  2. Main body ECU (instrument panel junction block)
  3. Wire harness or connector

WIRING DIAGRAM


B165251E03


INSPECTION PROCEDURE

1.CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

    HINT:
    After all DTCs are cleared, check if the trouble occurs again 6 seconds after the power switch is turned on (IG).

  1. Check for DTCs again.

    OK:
    No DTC is output.



NG
Go to step 2
OK

USE SYMPTOM METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) - BATTERY)


    B175597E01
  1. Disconnect the D7 and D8 ECU connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D8-6 (AM1) - Body ground
    Always
    11 to 14 V
    D7-1 (AM2) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR, OR FUSE
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)