DTC B2273 Ignition 2 Monitor Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2273 | IG2 relay actuation circuit inside main body ECU (instrument panel junction block) or other related circuit is malfunctioning |
|

| 1.READ VALUE USING TECHSTREAM |
Connect Techstream to the DLC3.
Turn the power switch on (IG) and turn Techstream main switch on.
Read the Data List according to the displays on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG2 Relay Monitor (Outside) | Status of IG2 relay monitor (outer) / ON or OFF | ON: Power switch on (IG) (IG2 relay is ON) OFF: Power switch off (IG2 relay is OFF) | - |
|
| ||||
| OK | |
| 2.CHECK DTC OUTPUT |
Delete the DTCs (Click here).
Check for DTCs again.
|
| ||||
| OK | ||
| ||
| 3.INSPECT RELAY (IG2 RELAY) |
![]() |
Remove the IG2 relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | When battery voltage is not applied to terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | When battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (ENGINE ROOM RELAY BLOCK - MAIN BODY ECU AND BODY GROUND) |
Disconnect the D7 ECU connector.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Engine room relay block IG2 relay terminal 1 - D7-11 (IG2D) | Always | Below 1 Ω |
| D7-11 (IG2D) - Body ground | Always | 10 kΩ or higher |
| Engine room relay block IG2 relay terminal 2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||