Home › ENGINE › 3MZ-FE STARTING › SMART KEY SYSTEM

DTC    B2277    Detecting Vehicle Submersion

for Preparation Click here


DESCRIPTION

This DTC is output when the submersion circuit monitor inside the main body ECU (instrument panel junction block) detects that the vehicle is submerged in water.

HINT:
When the main body ECU (instrument panel junction block) is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU (instrument panel junction block) is replaced, perform the registration procedures for the engine immobiliser system (Click here).


DTC No.
DTC Detection Condition
Trouble Area
B2277
Submersion circuit monitor inside main body ECU (instrument panel junction block) detects that vehicle is submerged in water
Main body ECU (instrument panel junction block)

INSPECTION PROCEDURE

1.CHECK FOR WATER DAMAGE
  1. Check the main body ECU (instrument panel junction block), peripheral components, and wire harnesses for traces of water.

    OK:
    There are no traces of water.



NG
TAKE APPROPRIATE MEASURES AGAINST CAUSE OF WATER DAMAGE AND REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
OK


2.CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

    HINT:
    After all DTCs are cleared, check if the trouble occurs again 270 to 330 seconds after the power switch is turned on (IG).

  1. Check for DTCs again.

    OK:
    No DTC is output.



NG
REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
OK

USE SYMPTOM METHOD TO CHECK (Click here)