Home › ENGINE › 3MZ-FE STARTING › SMART KEY SYSTEM

DTC    B2281    "P" Signal Malfunction

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU and the shift lock control ECU are connected by a cable and the CAN. If the cable information and CAN information are inconsistent, this DTC will be output.

HINT:
If the main body ECU (instrument panel junction block) is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored. After the main body ECU (instrument panel junction block) is replaced, perform the registration procedure for the engine immobiliser system (Click here).


DTC No.
DTC Detection Condition
Trouble Area
B2281
Cable information and CAN information between main body ECU (instrument panel junction block) and shift lock control ECU are inconsistent
  1. Main body ECU (instrument panel junction block)
  2. Shift lock control ECU
  3. Wire harness or connector

WIRING DIAGRAM


B176818E03


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect Techstream to the DLC3.

  1. Turn the power switch on (IG) and turn the Techstream main switch on.

  1. Read the DATA LIST according to the displays on the tester.

    Main Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Shift P Signal
    Shift P Signal / ON or OFF
    ON: Shift P signal ON (Shift position is P)
    OFF: Shift P signal OFF (Shift position is not P)
    -

    OK:
    "ON" (P signal is ON) and "OFF" (P signal is OFF) appear on the screen.



NG
GO TO SHIFT CONTROL SYSTEM
OK


2.CHECK WIRE HARNESS (MAIN BODY ECU - SHIFT LOCK CONTROL ECU)


  1. Disconnect the D10 and D21 ECU connectors.


    B138006E07

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Terminal No. (Symbol)
    Condition
    Specified Condition
    D10-2 (P) - D21-11 (P2)
    Always
    Below 1 Ω
    D10-2 (P) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK MAIN BODY ECU OPERATION
  1. After replacing the main body ECU (instrument panel junction block) with a normally functioning ECU, check that the hybrid control system can start normally.

    OK:
    Hybrid control system can start normally.



NG
REPLACE SHIFT LOCK CONTROL ECU (Click here)
OK

END (MAIN BODY ECU DEFECTIVE)