Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)

AIR CONDITIONING SYSTEM (for Manual Air Conditioning System) > Back-up Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the back-up power source circuit for the air conditioning amplifier. Power is supplied even when the power switch is turned off. The power is used for functions such as retaining the diagnostic trouble code memory.

WIRING DIAGRAM


E174119E03


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-B)
  1. Remove the ECU-B fuse from the engine room No. 1 relay block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-B fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY)


    E153377E12
  1. Disconnect the D37 and D38 amplifier connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D37-21 (B) - Body ground
    Always
    11 to 14 V
    D38-24 (+B2)* - Body ground
    Always
    11 to 14 V

    HINT:
    *: w/ Rear air conditioning



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BODY GROUND)


    E153377E13
  1. Disconnect the D37 and D38 amplifier connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D37-14 (GND) - Body ground
    Always
    Below 1 Ω
    D38-20 (GND2)* - Body ground
    Always
    Below 1 Ω

    HINT:
    *: w/ Rear air conditioning



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)