Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)

AIR CONDITIONING SYSTEM (for Manual Air Conditioning System) > LIN Communication Circuit

for Preparation Click here


DESCRIPTION

The operation signals of switches etc. are exchanged between terminal LIN1 of the air conditioning control assembly and terminal LIN1 of the air conditioning amplifier.

WIRING DIAGRAM


E153717E04


INSPECTION PROCEDURE

1.CHECK AIR CONDITIONING SYSTEM (OPERATION)

Result:

Result
Proceed to
Front air conditioning control malfunctions
A
Rear air conditioning control malfunctions
B



B
Go to step 3
A


2.CHECK HARNESS AND CONNECTOR (A/C CONTROL ASSEMBLY - AIR CONDITIONING AMPLIFIER)


    E152691E05
  1. Disconnect the connector from the air conditioning control assembly.

  1. Disconnect the connector from the air conditioning amplifier.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D37-37 (LIN1) - E10-5 (LIN1)
    Always
    Below 1 Ω
    D37-37 (LIN1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK HARNESS AND CONNECTOR (REAR AIR CONDITIONING CONTROL ASSEMBLY - AIR CONDITIONING AMPLIFIER)


    E153374E10
  1. Disconnect the connector from the rear air conditioning control assembly.

  1. Disconnect the connector from the air conditioning amplifier.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D38-13 (RLIN) - R1-5 (MPX-)
    Always
    Below 1 Ω
    D38-13 (RLIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)