Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > Certification ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit of the certification ECU (smart key ECU assembly).
The certification ECU (smart key ECU assembly) controls the following:
  1. Electrical key verification
  2. Indoor, outside and door oscillator control
  3. Entry door LOCK/UNLOCK request to the main body ECU (instrument panel junction block)
  4. Steering LOCK/UNLOCK request
  5. Immobiliser SET/UNSET request to the ID code box (immobiliser code ECU)

WIRING DIAGRAM


B171366E05


INSPECTION PROCEDURE

NOTICE:
If the certification ECU (smart key ECU assembly) is replaced, register the keys and ECU communication ID (Click here).

1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY)


    B171405E02
  1. Disconnect the certification ECU (smart key ECU assembly) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D40-1 (+B) - Body ground
    Always
    11 to 14 V
    D40-18 (IG) - Body ground
    Power switch off
    Below 1 V
    D40-18 (IG) - Body ground
    Power switch on (IG)
    11 to 14 V
    D40-19 (ACC) - Body ground
    Power switch off
    Below 1 V
    D40-19 (ACC) - Body ground
    Power switch on (ACC)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BODY GROUND)


    B171405E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D40-17 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (Click here)