Home › STEERING › STEERING COLUMN › STEERING LOCK SYSTEM

STEERING LOCK SYSTEM > INITIALIZATION

for Preparation Click here


HINT:
In vehicles equipped with the smart key system, the starting function may not operate after recharging or while jump-starting a discharged battery. This condition is most common if the battery voltage drops below 9 V. The following procedure has been developed to address this condition.


INITIALIZATION PROCEDURE
C178867E01
  1. Confirm that the SHORT fuse is installed.

    HINT:
    If the SHORT fuse is not installed, install it at this time.

  2. Move the shift lever to the N position.

  3. Turn the power switch off.

  4. Open the driver's door.

    HINT:
    Opening the driver's door will start an initialization process between the steering lock ECU and the engine room junction block.

  5. Depress the brake pedal.

  6. Press the "START STOP" switch.