Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Power Steering ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
Power Steering ECU Communication Stop Mode
  1. EPS is not displayed on "CAN Bus Check" screen of Techstream
  2. "Power Steering ECU Communication Stop Mode" in "DTC COMBINATION TABLE"
  1. Power source circuit of the power steering ECU
  2. Power steering ECU branch wire or connector
  3. Power steering ECU

WIRING DIAGRAM


C152888E07


INSPECTION PROCEDURE

NOTICE:
  1. Turn the power switch off before measuring the resistances of the main wire and the branch wire.
  2. After the power switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the power switch, any other switches or doors. If the doors need to be opened in order to check the connectors, open the doors and leave them open.

HINT:
  1. Operating the power switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below will help determine the cause of the malfunction.

1.CHECK CAN BUS WIRE FOR DISCONNECTION (POWER STEERING ECU BRANCH WIRE)
  1. Turn the power switch off.

  1. Disconnect the power steering ECU connector.



    C128052E10
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D6-2 (CANH) - D6-8 (CANL)
    Power switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE OR CONNECTOR (POWER STEERING ECU BRANCH WIRE)
OK


2.CHECK WIRE HARNESS (POWER STEERING ECU - BATTERY AND BODY GROUND)
  1. Disconnect the power steering ECU connectors.



    C160514E12
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D5-2 (PGND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D5-1 (PIG) - Body ground
    Always
    10 to 14 V
    D6-5 (IG) - Body ground
    Power switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU (Click here)