Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Door Mirror Foot Light Circuit

for Preparation Click here


DESCRIPTION

The illuminated entry system controls the door mirror foot lights.

WIRING DIAGRAM


E151669E01


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Main Body / Active Test.

  1. Check the operation.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Side Mirror Foot Light
    Door mirror foot lights
    ON / OFF
    -

    OK:
    Door mirror foot lights come on.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


    E151670E01
  1. Disconnect the D7 main body ECU connector.

  1. Using a service wire, connect D7-4 of the wire harness side and body ground.

    OK:
    Door mirror foot lights come on.



NG
Go to step 3
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) 

3.INSPECT FUSE (G/H)
  1. Remove the G/H fuse from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    G/H fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


4.INSPECT DOOR MIRROR FOOT LIGHT RELAY (MIR LP)


    B060778E87
  1. Remove the door mirror foot light relay from the No. 2 engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Apply the battery voltage between terminals 1 and 2
    Below 1 Ω



NG
REPLACE DOOR MIRROR FOOT LIGHT RELAY
OK


5.CHECK HARNESS AND CONNECTOR (BATTERY - DOOR MIRROR FOOT LIGHT RELAY)


    E151671E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    Door mirror foot light relay terminal 5 - Body ground
    Always
    11 to 14 V
    Door mirror foot light relay terminal 2 - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.CHECK HARNESS AND CONNECTOR (DOOR MIRROR FOOT LIGHT RELAY - MAIN BODY ECU)


  1. Disconnect the D7 main body ECU connector.


    E151676E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Door mirror foot light relay terminal 1 - D7-4 (MLRY)
    Always
    Below 1 Ω
    D7-4 (MLRY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (DOOR MIRROR FOOT LIGHT RELAY - MAIN BODY ECU)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (DOOR MIRROR FOOT LIGHT RELAY - BODY GROUND)