REPAIR INSTRUCTION > INSPECTION MODE PROCEDURE |
| INSPECTION MODE |
Vehicle conditions
Before activating inspection mode, turn the air conditioning off, start the engine with the shift lever in the P position, and check the engine stops within several seconds after starting (engine warm up check).
Activate inspection mode and inspect the vehicle. The shift position for each test is as follows:
| Test item | Inspection mode | Shift position |
| 1. Vehicle straight travelling test (side slip inspection) | 4WD inspection mode or normal | D |
| 2. Braking force test | 4WD inspection mode or normal | N |
| 3. Speedometer test | 2WD inspection mode | D |
| 4. Exhaust gas test (idling) | 4WD inspection mode | P |
| 5. Headlight test | 4WD inspection mode or normal | P |
Reset inspection mode immediately after completion of inspection.
Special notes for speedometer test
Depress the accelerator pedal slowly and gradually accelerate the vehicle. Make a measurement.
After the measurement, use the brakes to gradually decelerate the vehicle.
Special notes for using a chassis dynamometer
Always set an appropriate load before starting the test.
Activating 2WD inspection mode (Not using Techstream)
Perform the following steps from (1) through (4) in 60 seconds.
Turn the power switch on (IG).
Fully depress the accelerator pedal twice with the shift lever in the P position.
Fully depress the accelerator pedal twice with the shift lever in the N position.
Fully depress the accelerator pedal twice with the shift lever in the P position.
![]() |
Check that "2WD Maintenance Mode" is displayed on the multi-information display.
Start the engine by turning the power switch on (READY) while depressing the brake pedal.
Activating 2WD inspection mode (Using Techstream)
Connect Techstream to the DLC3.
Turn the power switch on (IG).
Turn Techstream on.
Select following menu items: Powertrain / Hybrid Control / Utility / Inspection Mode -2WD Inspection.
![]() |
Check that "2WD Maintenance Mode" is displayed on the multi-information display.
Start the engine by turning the power switch on (READY) while depressing the brake pedal.
Activating 4WD inspection mode (Not using Techstream)
Perform the following steps from (1) through (4) in 60 seconds.
Turn the power switch on (IG).
Fully depress the accelerator pedal four times with the shift lever in the P position.
Fully depress the accelerator pedal four times with the shift lever in the N position.
Fully depress the accelerator pedal four times with the shift lever in the P position.
![]() |
Check that "AWD Maintenance Mode" is displayed on the multi-information display.
Start the engine by turning the power switch on (READY) while depressing the brake pedal.
Activating 4WD inspection mode (Using Techstream)
Connect Techstream to the DLC3.
Turn the power switch on (IG).
Turn Techstream on.
Select following menu items: Powertrain / Hybrid Control / Utility / Inspection Mode -4WD Inspection.
![]() |
Check that "AWD Maintenance Mode" is displayed on the multi-information display.
Start the engine by turning the power switch on (READY) while depressing the brake pedal.
Deactivating inspection mode
Turn the power switch off. The HV system turns off simultaneously.