Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Television Display Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit of the television display assembly.

WIRING DIAGRAM


E153681E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - BATTERY, BODY GROUND)
E154378E01
  1. Disconnect the television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Q13-12 (GND6) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    Q13-16 (+B2) - Body ground
    Always
    11 to 14 V
    Q13-15 (ACC4) - Body ground
    Power switch on (ACC)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)