Home › BRAKE › BRAKE CONTROL › STOP LIGHT CONTROL RELAY

STOP LIGHT CONTROL RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT STOP LIGHT CONTROL RELAY
  1. Remove the stop light control relay.



    C126459E07
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Voltage is not applied between terminals 1 and 2
    Below 1 Ω
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 4
    Voltage is applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Voltage is applied between terminals 1 and 2
    Below 1 Ω

    If the resistance is not as specified, replace the stop light control relay.