CRUISE CONTROL SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Cruise Control / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| CCS Vehicle Spd | Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph) | Actual vehicle speed | - |
| CCS Mem Vehicle Spd | Stored vehicle speed / min.: 0 km/h (0 mph), max.: 200 km/h (125 mph) | Actual stored vehicle speed | - |
| Throttle Opening Angle | Required throttle opening angle / min.: 0°, max.: 125° | Actual required throttle opening angle | - |
| Cruise Control | Cruise control system active condition / ON or OFF | ON: Cruise control activated OFF: Cruise control deactivated | - |
| Main SW M-CPU | Main switch signal (Main CPU) / ON or OFF | ON: Main switch ON OFF: Main switch OFF | "3" |
| CCS Ready M-CPU | Cruise control system standby condition (Main CPU) / ON or OFF | ON - OFF: Change ON/OFF each time main switch is pushed in. | "1" |
| CCS Indicator M-CPU | Cruise indicator signal (Main CPU) / ON or OFF | ON: "CRUISE" ON OFF: "CRUISE" OFF | "2" |
| Cancel Switch | CANCEL switch signal / ON or OFF | ON: CANCEL switch ON OFF: CANCEL switch OFF | - |
| SET/COAST Switch | -/SET switch signal / ON or OFF | ON: -/SET switch ON OFF: -/SET switch OFF | - |
| RES/ACC Switch | +/RES switch signal / ON or OFF | ON: +/RES switch ON OFF: +/RES switch OFF | - |
| Stop Light SW M-CPU | Stop light switch signal (Main CPU) / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
| Cruise Operation Status | Transmission range sensor signal / ON or OFF | ON: Shift lever in D position OFF: Shift lever in any position except in D position | - |
| Vehicle Spd Change | Vehicle speed sudden change signal / ON or OFF | ON: Vehicle speed suddenly changed OFF: Vehicle speed not suddenly changed | - |
| #Codes | Number of DTC recorded / 0 to 255 | Number of DTCs will be displayed | - |
| PERFORM ACTIVE TEST |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform "Active Test" according to the display on the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp Cruise | CRUISE main indicator light | Indicator light BLINK / OFF | - |