POWER STEERING SYSTEM > FREEZE FRAME DATA |
| FREEZE FRAME DATA |
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Check the freeze frame data by following the prompts on the Techstream display. Enter the following menus: Chassis / EMPS / Utility / Freeze Frame Data.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Meter Vehicle Velocity | Vehicle speed from meter: Min.: 0 km/h (0 mph) Max.: 300 km/h (187.5 mph) | 0 km/h (mph) | Vehicle stopped |
| No significant fluctuation | Vehicle driven at a constant speed | ||
| Engine Revolution | Shows the engine speed: Min.: 0 rpm Max.: 12800 rpm | No significant fluctuation | Engine is running at a constant speed |
| Motor Actual Current | Amount of current to motor: Min.: -327.68 A Max.: 327.67 A | Value changes in proportion to steering effort | Power steering is in operation |
| Command Value Current | Demanded amount of current to motor: Min.: -327.68 A Max.: 327.68 A | Value changes in proportion to steering effort | Power steering is in operation |
| Steering Angle Velocity | Steering angle speed: Min.: -32768°/sec. Max.: 32767°/sec. | Value changes in proportion to steering effort | Steering wheel is turned |
| Thermistor Temperature | ECU substrate temperature: Min.: -40°C Max.: 150°C | -40 to 150°C | Power switch on (IG) |
| PIG Power Supply | Power source voltage to activate motor: Min.: 0 V Max.: 20.1531 V | 11 to 14 V | Power steering is in operation |
| IG Power Supply | ECU power source voltage: Min.: 0 V Max.: 20.1531 V | 11 to 14 V | Power switch on (IG) |
| Motor Rotation Angle | Motor rotation angle: Min.: 0° Max.: 360° | During steering operation, motor rotation angle value changes from 0 to 360° | Power steering is in operation |
| Motor Voltage | Motor power supply voltage: Min.: 0 V Max.: 45.955 V | 11 to 14 V | Power steering is in operation |
| Motor Terminal Volt(U) | Motor terminal voltage (U phase): Min.: 0 V Max.: 46.667 V | When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed. | Engine running and steering wheel is turned |
| Motor Terminal Volt(V) | Motor terminal voltage (V phase): Min.: 0 V Max.: 46.667 V | When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed. | Engine running and steering wheel is turned |
| Motor Terminal Volt(W) | Motor Terminal voltage (W phase): Min.: 0 V Max.: 46.667 V | When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed. | Engine running and steering wheel is turned |
| Battery Voltage | Battery voltage: Min.: 0 V Max.: 25.5 V | 11 to 14 V | - |
| PS Assist Signal | Power steering assist signal: ON or OFF | ON: Power steering assist signal is sent | Power switch on (IG) and steering wheel is turned |
| OFF: Power steering assist signal is not sent | No steering load (in centered position) |