Home › STEERING › POWER STEERING › POWER STEERING SYSTEM

POWER STEERING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK POWER STEERING ECU

F100917E07


HINT:
As connector "z6" uses a lock lever, each terminal cannot be checked while the connector is still connected to the power steering ECU.

Terminal No. (Symbols)
Wiring Color
Terminal Description
z6-1 (U)
W
U phase motor output
z6-2 (W)
W-R
W phase motor output
z6-3 (V)
B
V phase motor output

  1. Measure the voltage and resistance according to the value(s) in the table below.

    NOTICE:
    When the P/S warning light is illuminated due to a malfunction, the fail-safe function may cause the voltage of the power steering ECU's terminal to become 0 V.


    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D5-1 (PIG) - D5-2 (PGND)
    B - W
    Power source
    Always
    11 to 14 V
    D6-5 (IG) - D5-2 (PGND)
    G - W
    IG power source
    Power switch on (IG)
    11 to 14 V
    z5-1 (TRQ1) - z5-6 (TRQG)
    G - B
    Torque sensor signal
    Power switch on (IG), steering wheel not turned (without load)
    2.3 to 2.7 V
    Power switch on (IG), steering wheel turned to right with vehicle stopped
    2.5 to 4.04 V
    Power switch on (IG), steering wheel turned to left with vehicle stopped
    0.95 to 2.5 V
    z5-5 (TRQ2) - z5-6 (TRQG)
    Y - B
    Torque sensor signal
    Power switch on (IG), steering wheel not turned (without load)
    2.3 to 2.7 V
    Power switch on (IG), steering wheel turned to right with vehicle stopped
    0.95 to 2.5 V
    Power switch on (IG), steering wheel turned to left with vehicle stopped
    2.5 to 4.04 V
    z5-3 (TRQF) - z5-6 (TRQG)
    W - B
    Torque sensor reference voltage
    Power switch on (IG)
    3.35 to 3.37 V
    z5-4 (TRQV) - z5-6 (TRQG)
    R - B
    Torque sensor voltage source
    Power switch on (IG)
    8.5 to 10.5 V
    z5-6 (TRQG) - Body ground
    B - Body ground
    Torque sensor ground
    Always
    Below 1 Ω
    D5-2 (PGND) - Body ground
    W - Body ground
    Power ground
    Always
    Below 1 Ω
    z7-1 (C1) - D5-2 (PGND)
    R - W
    Resolver signal
    Power switch on (IG), steering wheel is turned
    0.68 to 4.42 V
    z7-5 (C2) - D5-2 (PGND)
    L - W
    Resolver signal
    Power switch on (IG), steering wheel is turned
    0.68 to 4.42 V
    z7-2 (S1) - D5-2 (PGND)
    B - W
    Resolver signal
    Power switch on (IG), steering wheel is turned
    0.68 to 4.42 V
    z7-6 (S2) - D5-2 (PGND)
    Y - W
    Resolver signal
    Power switch on (IG), steering wheel is turned
    0.68 to 4.42 V
    z7-4 (R1) - D5-2 (PGND)
    W - W
    Resolver excitation signal
    Power switch on (IG), steering wheel is turned
    2.9 to 5.1 V
    z7-8 (R2) - D5-2 (PGND)
    G - W
    Resolver excitation signal
    Power switch on (IG), steering wheel is turned
    2.9 to 5.1 V
    D6-2 (CANH) - D6-8 (CANL)
    B - W
    CAN communication line
    Power switch off
    54 to 67 Ω
    If the result is not as specified, the ECU may have a malfunction.