Home › BODY ELECTRICAL › LIGHTING › TAILLIGHT RELAY

TAILLIGHT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT TAILLIGHT RELAY


    A087121E11
  1. Remove the taillight relay from the instrument panel junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω (When battery voltage is applied to terminals 1 and 2)
    3 - 4
    Below 1 Ω
    10 kΩ or higher (When battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the taillight relay.