Home › BODY ELECTRICAL › LIGHTING › BACK-UP LIGHT RELAY

BACK-UP LIGHT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT BACK-UP LIGHT RELAY


    B060778E85
  1. Remove the back-up light relay from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher (When battery voltage is not applied to terminals 1 and 2)
    Below 1 Ω (When battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the back-up light relay.