Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

DTC    B1441/41    Air Mix Damper Control Servo Motor Circuit (Passenger Side)

for Preparation Click here


DESCRIPTION

The air mix control servo motor sends pulse signals to indicate the damper position to the air conditioning amplifier. The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the air mix damper (front passenger side) to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the blown air. The air conditioning amplifier communicates with the servo through a communication/driver IC and wiring assembly called the air conditioning harness.

HINT:
Confirm that there are no mechanical problems because this DTC can be set if either a damper link or the damper is mechanically locked.


DTC No.
DTC Detection Condition
Trouble Area
B1441/41
Air mix damper position does not change even if air conditioning amplifier operates air mix control servo motor.
  1. Air mix control servo motor
  2. Air conditioning harness
  3. Air conditioning amplifier

WIRING DIAGRAM


E133419E05


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and turn the Techstream main switch on.

  1. Select the items below in the Data List, and read the value displayed on the Techstream.

    Data List / Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Mix Sensor Targ Pulse(P)
    Passenger side air mix control servo motor target pulse /
    Min.: 0, Max.: 255
    MAX. COLD: 105 (pulse)
    MAX. HOT: 7 (pulse)
    -

    OK:
    The display is as specified in the normal condition column.


    Result:

    Result
    Proceed to
    NG
    A
    OK (When troubleshooting according to PROBLEM SYMPTOMS TABLE)
    B
    OK (When troubleshooting according to DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER
A


2.REPLACE AIR MIX CONTROL SERVO MOTOR
  1. Replace the air mix control servo motor .


NEXT


3.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B1441/41 is not output.



NG
REPAIR OR REPLACE AIR CONDITIONING HARNESS
OK

END (AIR MIX CONTROL SERVO MOTOR IS DEFECTIVE)