DTC B1441/41 Air Mix Damper Control Servo Motor Circuit (Passenger Side) |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1441/41 | Air mix damper position does not change even if air conditioning amplifier operates air mix damper control servo motor. |
|

| 1.READ VALUE USING TECHSTREAM (AIR MIX PULSE-P) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG) and turn the Techstream main switch on.
Select the items below in the Data List, and read the value displayed on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Air Mix Sensor Targ Pulse(P) | Passenger side air mix servo motor target pulse / Min.: 0, Max.: 255 | MAX. COLD: 105 (pulse) MAX HOT: 7 (pulse) | - |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to PROBLEM SYMPTOMS TABLE)) | B |
| OK (When troubleshooting according to DTC)) | C |
|
| ||||
|
| ||||
| A | |
| 2.REPLACE AIR MIX CONTROL SERVO MOTOR |
Replace the air mix control servo motor .
| NEXT | |
| 3.CHECK DTC OUTPUT |
Check for DTCs.
|
| ||||
| OK | ||
| ||