Home › BODY ELECTRICAL › DOOR LOCK › FRONT DOOR LOCK

FRONT DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT FRONT DOOR LOCK ASSEMBLY (for Driver Side)


    B171377E01
  1. Apply the battery voltage to the motor terminals and check the operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 4 (L)
    Battery negative (-) → 1 (UL)
    Locked
    Battery positive (+) → 1 (UL)
    Battery negative (-) → 4 (L)
    Unlocked

    If the result is not as specified, replace the door lock assembly.

  1. Measure the resistance of the door lock position switch.

    Standard resistance:
    Tester Connection
    Measurement Condition
    Door Lock Condition
    Specified Condition
    7 - 8
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Locked
    10 kΩ or higher
    7 - 8
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlocked
    Below 1 Ω

    If the result is not as specified, replace the door lock assembly.



    B164389E06
  1. Measure the resistance of the door key lock and unlock switch operation.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    7 - 9
    Locked
    Below 1 Ω
    7 - 9
    7 - 10
    OFF (Free)
    10 kΩ or higher
    7 - 10
    Unlocked
    Below 1 Ω

    If the result is not as specified, replace the door lock assembly.



2. INSPECT FRONT DOOR LOCK ASSEMBLY (for Front Passenger Side)


    B171378E02
  1. Apply the battery voltage to the motor terminals and check the operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Locked
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlocked

  1. Measure the resistance of the door lock position switch.

    Standard resistance:
    Tester Connection
    Measurement Condition
    Door Lock Condition
    Specified Condition
    7 - 8
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Locked
    10 kΩ or higher
    7 - 8
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlocked
    Below 1Ω

    If the result is not as specified, replace the door lock assembly.