Home › BODY ELECTRICAL › DOOR LOCK › REAR DOOR LOCK

REAR DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT REAR DOOR LOCK ASSEMBLY LH


    B164415E01
  1. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Locked
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    If the result is not as specified, replace the door lock assembly.
    Unlocked

  1. Measure the resistance of the door lock position switch.

    Standard resistance:
    Tester Connection
    Measurement Condition
    Door Lock Condition
    Specified Condition
    6 - 9
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Locked
    10 kΩ or higher
    6 - 9
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlocked
    Below 1 Ω

    If the result is not as specified, replace the door lock assembly.



2. INSPECT REAR DOOR LOCK ASSEMBLY RH


    B164416E01
  1. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Locked
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlocked

    If the result is not as specified, replace the door lock assembly.

  1. Measure the resistance of the door lock position switch.

    Standard resistance:
    Tester Connection
    Measurement Condition
    Door Lock Condition
    Specified Condition
    6 - 9
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Locked
    10 kΩ or higher
    6 - 9
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlocked
    Below 1 Ω

    If the result is not as specified, replace the door lock assembly.