Home › BODY ELECTRICAL › LIGHTING › BACK DOOR COURTESY SWITCH

BACK DOOR COURTESY SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR LOCK ASSEMBLY (w/o Power Back Door)


    B164421E08
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 3
    Lock
    10 kΩ or higher
    Unlock
    Below 1 Ω

    If the result is not specified, replace the back door lock assembly.



2. INSPECT BACK DOOR LOCK ASSEMBLY (w/ Power Back Door)


  1. Measure the resistance according to the value(s) in the table below.


    E151699E01

    Standard resistance:
    Tester Connection
    Door Lock Latch Position
    Specified Condition
    3 - 4
    Open-latch
    Below 1 Ω
    Half-latch
    Below 1 Ω
    Full-latch
    10 kΩ or higher
    Over-latch
    10 kΩ or higher

    If the result is not specified, replace the back door lock assembly.