Home › BODY ELECTRICAL › DOOR LOCK › BACK DOOR LOCK

BACK DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR LOCK ASSEMBLY (w/o Power Back Door)


    B164421E07
  1. Check operation of the door lock motor.

    1. Move the door lock to the lock position.

    2. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 2
      Battery negative (-) → 1
      Unlocked

      If the result is not specified, replace the back door lock.

  1. Check operation of the door courtesy switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 3
      Locked
      10 kΩ or higher
      1 - 3
      Unlocked
      Below 1 Ω

      If the result is not specified, replace the back door lock.



2. INSPECT BACK DOOR LOCK ASSEMBLY (w/ Power Back Door)


  1. Check operation of the door lock motor.


    B143899E07


    1. Move the door lock to the lock position.

    2. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1 (DC+)
      Battery negative (-) → Terminal 2 (DC-)
      Latch turns to full-latch position
      Battery positive (+) → Terminal 2 (DC-)
      Battery negative (-) → Terminal 1 (DC+)
      Latch turns to open-latch position

      If the result is not specified, replace the back door lock.

  1. Check operation of the switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Full-latch switch:
      Tester Connection
      Door Lock Latch Position
      Specified Condition
      5 (HAF) - 4 (GND)
      Over-latch
      Below 1 Ω
      5 (HAF) - 4 (GND)
      Open-latch
      10 kΩ or higher
      5 (HAF) - 4 (GND)
      Full-latch
      10 kΩ or higher
      5 (HAF) - 4 (GND)
      Half-latch
      10 kΩ or higher
      Sector switch:
      Tester Connection
      Door Lock Latch Position
      Specified Condition
      6 (POS) - 4 (GND)
      Open-latch
      Below 1 Ω
      6 (POS) - 4 (GND)
      Over-latch
      10 kΩ or higher
      6 (POS) - 4 (GND)
      Full-latch
      10 kΩ or higher
      6 (POS) - 4 (GND)
      Half-latch
      10 kΩ or higher
      Back door courtesy light switch:
      Tester Connection
      Door Lock Latch Position
      Specified Condition
      3 (BDCY) - 4 (GND)
      Open-latch
      Below 1 Ω
      3 (BDCY) - 4 (GND)
      Half-latch
      Below 1 Ω
      3 (BDCY) - 4 (GND)
      Full-latch
      10 kΩ or higher
      3 (BDCY) - 4 (GND)
      Over-latch
      10 kΩ or higher

      If the result is not specified, replace the back door lock.