REAR SEAT ENTERTAINMENT SYSTEM > Sound Signal Circuit between Video Terminal and Television Display |

| 1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - VIDEO TERMINAL) |
![]() |
Disconnect the television display assembly connector.
Disconnect the video terminal connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Q13-7 (AUXR) - O25-1 (VAR+) | Always | Below 1 Ω |
| Q13-8 (AUXL) - O25-2 (VAL+) | Always | Below 1 Ω |
| Q13-23 (SG7) - O25-3 (VA-) | Always | Below 1 Ω |
| Q13-24 (OPEN) - O25-8 (ADPG) | Always | Below 1 Ω |
| Q13-7 (AUXR) - Body ground | Always | 10 kΩ or higher |
| Q13-8 (AUXL) - Body ground | Always | 10 kΩ or higher |
| Q13-23 (SG7) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT VIDEO TERMINAL |
![]() |
Using an oscilloscope, check the signal waveform between each terminal and body ground according to the conditions shown in the table below.
| Tester Connection | Condition | Specified Condition |
| O25-1 (VAR+) - Body ground | External device system is playing, sound is being produced | Waveform synchronized with sound is output |
| O25-2 (VAL+) - Body ground | External device system is playing, sound is being produced | Waveform synchronized with sound is output |
|
| ||||
| OK | ||
| ||