Home › BODY ELECTRICAL › LIGHTING › TURN SIGNAL FLASHER ASSEMBLY

TURN SIGNAL FLASHER ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT TURN SIGNAL FLASHER ASSEMBLY


    E142629E06
  1. Disconnect the D12 turn signal flasher assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D12-1 (IG) - Body ground
    Power switch off
    Below 1 V
    Power switch on (IG)
    11 to 14 V
    D12-4 (B) - Body ground
    Always
    11 to 14 V

    If the result is not as specified, there is a malfunction on the wire harness side.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D12-5 (EL) - Body ground
    Turn signal switch OFF
    11 kΩ or higher
    Turn signal switch in LH position
    Below 1 Ω
    D12-6 (ER) - Body ground
    Turn signal switch OFF
    11 kΩ or higher
    Turn signal switch in RH position
    Below 1 Ω
    D12-7 (E) - Body ground
    Always
    Below 1 Ω
    D12-8 (HAZ) - Body ground
    Hazard warning switch OFF
    11 kΩ or higher
    Hazard warning switch ON
    Below 1 Ω

    If the result is not as specified, there is a malfunction on the wire harness side.



    E142615E06
  1. Reconnect the D12 turn signal flasher assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D12-2 (LR) - Body ground
    Hazard warning switch OFF
    Below 1 V
    Hazard warning switch ON
    11 to 14 V (60 to 120 times per minute)
    Turn signal switch OFF
    Below 1 V
    Power switch on (IG) and turn signal switch in RH position
    11 to 14 V (60 to 120 times per minute)
    D12-3 (LL) - Body ground
    Hazard warning switch OFF
    Below 1 V
    Hazard warning switch ON
    11 to 14 V (60 to 120 times per minute)
    Turn signal switch OFF
    Below 1 V
    Power switch on (IG) and turn signal switch in LH position
    11 to 14 V (60 to 120 times per minute)

    If the result is not as specified, replace the turn signal flasher assembly.