AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO JACK ADAPTER) |
![]() |
Disconnect the connectors from the stereo jack adapter and the radio receiver.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E12-4 (AUXO) - E3-19 (AUXI) | Always | Below 1 Ω |
| E12-3 (ASGN) - E3-16 (ASGN) | Always | Below 1 Ω |
| E12-2 (ARO) - E3-15 (ARI) | Always | Below 1 Ω |
| E12-1 (ALO) - E3-17 (ALI) | Always | Below 1 Ω |
| E12-5 (AGND) - E3-18 (AGND) | Always | Below 1 Ω |
| E12-4 (AUXO) - Body ground | Always | 10 kΩ or higher |
| E12-3 (ASGN) - Body ground | Always | 10 kΩ or higher |
| E12-2 (ARO) - Body ground | Always | 10 kΩ or higher |
| E12-1 (ALO) - Body ground | Always | 10 kΩ or higher |
| E12-5 (AGND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||