Home › BODY ELECTRICAL › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR COMBINATION LIGHT ASSEMBLY


    E151682E01
  1. Disconnect the connectors from the rear combination light assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    LH Side:
    Tester Connection
    Condition
    Specified Condition
    O29-1 - O29-2
    Light control switch OFF
    Below 1 V
    Light control switch in TAIL
    11 to 14 V
    O29-1 - O29-3
    Brake pedal released
    Below 1 V
    Brake pedal depressed
    11 to 14 V
    O27-1 - O27-2
    Turn signal switch OFF
    Below 1 V
    Power switch on (IG) and Turn signal switch in LH
    11 to 14 V (60 to 120 times per minute)
    O13-1 - O13-2
    Shift lever not in R
    Below 1 V
    Shift lever in R
    11 to 14 V
    RH Side:
    Tester Connection
    Condition
    Specified Condition
    O30-1 - O30-2
    Light control switch OFF
    Below 1 V
    Light control switch in TAIL
    11 to 14 V
    O30-1 - O30-3
    Brake pedal released
    Below 1 V
    Brake pedal depressed
    11 to 14 V
    O28-1 - O28-2
    Turn signal switch OFF
    Below 1 V
    Power switch on (IG) and Turn signal switch in LH
    11 to 14 V (60 to 120 times per minute)
    O14-1 - O14-2
    Shift lever not in R
    Below 1 V
    Shift lever in R
    11 to 14 V

    If the result is not as specified, there is a malfunction on the wire harness side.