Home › BODY ELECTRICAL › LIGHTING › ROOM LIGHT ASSEMBLY (for Rear)

ROOM LIGHT ASSEMBLY (for Rear) > INSPECTION

for Preparation Click here



1. INSPECT NO. 2 ROOM LIGHT ASSEMBLY


E151683E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Q9-2 - Body ground
    Always
    Below 1 Ω

    If the result is not as specified, repair or replace harness or connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    Q9-1 - Body ground
    Always
    11 to 14 V

    If the result is not as specified, repair or replace the harness or connector.