Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING PRESSURE SENSOR

AIR CONDITIONING PRESSURE SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT A/C PRESSURE SENSOR
  1. Install the manifold gauge set.

  1. Disconnect the connector from the A/C pressure sensor.



    E107326E13
  1. Connect the three 1.5 V dry cell batteries' positive (+) lead to terminal 3 and the negative (-) lead to terminal 1.

  1. Connect the voltmeter's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    2 - 1
    Refrigerant pressure:
    0.39 to 3.187 MPa (57 to 463 psi)
    1.0 to 4.8 V

    If the result is not as specified, replace the A/C pressure sensor.