Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

DTC    B1242    Wireless Door Lock Tuner Circuit Malfunction

for Preparation Click here


DESCRIPTION

  1. The electrical key antenna is used to receive electric waves relating to the entry functions of the smart key system with push-button start. The certification ECU (smart key ECU assembly) decodes the requested smart key system with push-button start operation by identifying a key code based on electric waves received via the electrical key antenna and the door control receiver.
  2. The door control receiver receives a signal from the wireless door control transmitter and sends signals to the main body ECU through the certification ECU (smart key ECU assembly).
  3. The certification ECU (smart key ECU assembly) then sends a command, according to the requested operation, to each ECU. (e.g. If door lock operation is requested, the ECU sends a door lock command to the main body ECU.)

DTC No.
DTC Detection Condition
Trouble Area
B1242
The certification ECU (smart key ECU assembly) detects that there is a short in the circuit between terminals RSSI, or between terminals DATA and RDA.
  1. Door Control Receiver
  2. Wire harness
  3. Certification ECU (Smart key ECU assembly)

WIRING DIAGRAM


B175266E05


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - DOOR CONTROL RECEIVER)


    B189913E01
  1. Disconnect the D40 certification ECU (smart key ECU assembly) connector and O26 door control receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D40-39 (RSSI) - O26-2 (RSSI)
    Always
    Below 1 Ω
    D40-38 (RDA) - O26-5 (DATA)
    Always
    Below 1 Ω
    D40-39 (RSSI) - Body ground
    Always
    10 kΩ or higher
    D40-38 (RDA) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
B178879E05
  1. Reconnect the D40 certification ECU (smart key ECU assembly) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D40-39 (RSSI) - D40-17 (E)
    power switch off, all doors closed, the electrical key is not in the actuation area
    Below 1 V
    power switch off, all doors closed, the electrical key is in the actuation area
    4.6 to 5.4 V
    D40-38 (RDA) - D40-17 (E)
    power switch off, all doors closed and transmitter switch not pressed
    Below 1 V
    power switch off, all doors closed and transmitter switch pressed
    4.6 to 5.4 V



NG
REPLACE DOOR CONTROL RECEIVER (Click here)
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)