Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Sound Signal Circuit between Navigation Receiver Assembly and Television Display Assembly

for Preparation Click here


DESCRIPTION

The television display assembly sends an RSE sound signal to the navigation receiver assembly through this circuit. The sound signal that has been sent is amplified by the stereo component amplifier, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, navigation receiver assembly or speakers.

WIRING DIAGRAM


E152222E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)


    E126469E14
  1. Disconnect television display assembly connector Q13 and navigation receiver assembly connector E15.



    E150773E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E15-2 (CDR+) - Q13-28 (R+)
    Always
    Below 1 Ω
    E15-3 (CDR-) - Q13-29 (R-)
    Always
    Below 1 Ω
    E15-4 (CDL+) - Q13-30 (L+)
    Always
    Below 1 Ω
    E15-5 (CDL-) - Q13-31 (L-)
    Always
    Below 1 Ω
    E15-1 (CSLD) - Q13-27 (SG1)
    Always
    Below 1 Ω
    Q13-29 (R-) - Body ground
    Always
    10 kΩ or higher
    Q13-30 (L+) - Body ground
    Always
    10 kΩ or higher
    Q13-31 (L-) - Body ground
    Always
    10 kΩ or higher
    Q13-28 (R+) - Body ground
    Always
    10 kΩ or higher
    Q13-27 (SG1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT TELEVISION DISPLAY ASSEMBLY


    E153728E01
  1. Reconnect television display assembly connector Q13.

  1. Check the waveform according to the conditions in the table below.

    Standard resistance:

    Tester Connection
    Condition
    Specified Condition
    Q13-28 (R+) - Body ground
    Voice sound is being produced
    A waveform synchronized with sound is output
    Q13-29 (R-) - Body ground
    Voice sound is being produced
    A waveform synchronized with sound is output
    Q13-30 (L+) - Body ground
    Voice sound is being produced
    A waveform synchronized with sound is output
    Q13-31 (L-) - Body ground
    Voice sound is being produced
    A waveform synchronized with sound is output



NG
REPLACE TELEVISION DISPLAY ASSEMBLY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)