Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Display Signal Circuit between Television Display Assembly and Navigation Receiver Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a DVD image signal from the television display assembly to the navigation receiver assembly.

WIRING DIAGRAM


E153684E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - TELEVISION DISPLAY ASSEMBLY)


    E150771E01
  1. Disconnect navigation receiver assembly connector E6 and television display assembly connector Q13.



    E126469E16
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E6-1 (VV+) - Q13-11 (NTS1)
    Always
    Below 1 Ω
    E6-4 (VV-) - Q13-10 (SG3)
    Always
    Below 1 Ω
    E6-1 (VV+) - Body ground
    Always
    10 kΩ or higher
    E6-4 (VV-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT TELEVISION DISPLAY ASSEMBLY


    E153728E03
  1. Reconnect television display assembly connector Q13.

  1. Measure the waveform according to the table below.

    OK:
    Tester Connection
    Condition
    Specified Condition
    Q13-11 (NTS1) - Body ground
    DVD display is ON
    A waveform synchronized with display signals is output

    HINT:
    The waveform pattern may differ from that shown in the illustration below due to differences in the oscilloscope setting. A normal television display assembly operating condition can be determined if any waveform is output.



    E111833E02
  1. Oscilloscope waveform

    1. Terminal: Q13-11 (NTS1) - Body ground
      Setting: 200 mV/DIV., 10 μs/DIV.
      Condition: DVD display is ON.



NG
REPLACE TELEVISION DISPLAY ASSEMBLY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)