NAVIGATION SYSTEM > Mute Signal Circuit between Navigation Receiver Assembly and Television Display Assembly |

| 1.INSPECT TELEVISION DISPLAY ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Q13-26 (LMUT) - Body ground | Power switch on (ACC), RSE system is playing → Changing mode | Above 3.5 V → Below 1 V |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - TELEVISION DISPLAY ASSEMBLY) |
![]() |
Disconnect navigation receiver assembly connector E15 and television display assembly connector Q13.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E15-6 (MUTE) - Q13-26 (LMUT) | Always | Below 1 Ω |
| E15-6 (MUTE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE TELEVISION DISPLAY ASSEMBLY |
Replace the television display assembly and check if it operates normally (Click here).
|
| ||||
| OK | ||
| ||