Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

This circuit sends a signal to the stereo component amplifier to mute noise. Because of that, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier is functioning normally, no sound, or only an extremely faint sound, can be heard.

WIRING DIAGRAM


E153585E02


INSPECTION PROCEDURE

1.INSPECT STEREO COMPONENT AMPLIFIER


    E153729E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    N14-1 (MUTE) - Body ground
    Power switch on (ACC), Audio system is playing → Changing
    Above 3.5 V → Below 1 V



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - STEREO COMPONENT AMPLIFIER)


    I101978E30
  1. Disconnect navigation receiver assembly connector E2 and stereo component amplifier connector N14.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E2-7 (MUTE) - N14-1 (MUTE)
    Always
    Below 1 Ω
    E2-7 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT STEREO COMPONENT AMPLIFIER (OUTPUT SIGNAL)


    E153729E01
  1. Reconnect stereo component amplifier connector N14.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    N14-1 (MUTE) - Body ground
    Power switch on (ACC)
    Audio system is playing
    Above 3.5 V



NG
REPLACE STEREO COMPONENT AMPLIFIER (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)