Home › ENGINE › 3MZ-FE STARTING › SMART KEY SYSTEM

DTC    B2288    Steering Lock Signal Circuit Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when the main body ECU (instrument panel junction block) cannot detect the unlock condition of the steering lock within a specified time.

HINT:
When the main body ECU (instrument panel junction block) is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU (instrument panel junction block) is replaced, perform the registration procedures for the engine immobiliser system (Click here).


DTC No.
DTC Detection Condition
Trouble Area
B2288
After turning power switch from off to on (IG), the steering wheel does not unlock for a certain period of time (ECU unlocks steering wheel only when it receives an unlock signal from LIN communication and cable)
  1. Main body ECU (instrument panel junction block)
  2. Steering lock ECU
  3. Wire harness or connector

WIRING DIAGRAM


B176786E03


INSPECTION PROCEDURE

1.CHECK FOR DTCS
  1. Delete the DTCs (Click here).

  1. After all DTCs are cleared, check if the trouble occurs again 18 to 22 seconds after the power switch is turned on (IG).

  1. Check for DTCs again.

    Result:

    Result
    Proceed to
    DTC B2285 (Steering lock Position Signal Circuit Malfunction) is output
    A
    Steering lock DTCs B2781, B2782 and / or B2788 are output
    B
    DTC B2288 is output
    C



A
GO TO DIAGNOSTIC TROUBLE CODE CHART (DTC B2285) (Click here)

B
GO TO DIAGNOSTIC TROUBLE CODE CHART (DTC B2781, B2782, B2788) (Click here)
C


2.CHECK STEERING LOCK
  1. Check if the steering lock is released when turning the power switch on (ACC).

    OK:
    The steering lock is released.



NG
GO TO STEERING LOCK SYSTEM (Click here)
OK


3.READ VALUE USING TECHSTREAM
  1. Connect Techstream to the DLC3.

  1. Check the DATA LIST for proper functioning of the steering lock function.

    HINT:
    When using Techstream with the power switch off, turn on and off any of the door courtesy light switches repeatedly at 1.5 second intervals or less until communication between the tester and vehicle starts.


    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Steering Unlock Switch
    Steering lock condition / ON or OFF
    ON: Steering is unlocked (Power switch on (ACC))
    OFF: Steering is locked (Power switch off)
    -



NG
REPLACE STEERING LOCK ECU (Click here)
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)