Home › STEERING › POWER STEERING › POWER STEERING SYSTEM

DTC    C1511    Torque Sensor Circuit Malfunction

DTC    C1512    Torque Sensor Circuit Malfunction

DTC    C1513    Torque Sensor Circuit Malfunction

DTC    C1514    Torque Sensor Power Supply Abnormal

for Preparation Click here


DESCRIPTION

The torque sensor converts the rotation torque input from the steering wheel into electric signals and sends them to the power steering ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1511
Torque sensor (TRQ1) signal error or stop
  1. Steering column assembly (Torque sensor)
  2. Power steering ECU
C1512
Torque sensor (TRQ2) signal error or stop
C1513
Deviation between torque sensor TRQ1 and TRQ2 exceeds specified value
C1514
Torque sensor power source voltage error

WIRING DIAGRAM


C170024E01


INSPECTION PROCEDURE

1.CHECK CONNECTOR CONNECTION CONDITION (TORQUE SENSOR - POWER STEERING ECU)
  1. Check the installation condition of the torque sensor connector.

    OK:
    Torque sensor connector is securely installed to the power steering ECU.

    Result:
    Result
    Proceed to
    NG
    A
    OK
    B



B
Go to step 3
A


2.RECONFIRM DTC
  1. Reinstall the torque sensor connector.

  1. Check for DTCs (Click here).

    OK:
    DTC is not output.

    Result:
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A


3.CHECK TORQUE SENSOR


    C166749E02
  1. Turn the power switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    z5-1 (TRQ1) - z5-6 (TRQG)
    Steering wheel not turned (without load)
    2.3 to 2.7 V
    Steering wheel turned to right with vehicle stopped
    2.5 to 4.04 V
    Steering wheel turned to left with vehicle stopped
    0.95 to 2.5 V
    z5-5 (TRQ2) - z5-6 (TRQG)
    Steering wheel not turned (without load)
    2.3 to 2.7 V
    Steering wheel turned to right with vehicle stopped
    0.95 to 2.5 V
    Steering wheel turned to left with vehicle stopped
    2.5 to 4.04 V
    z5-3 (TRQF) - z5-6 (TRQG)
    Always
    3.35 to 3.37 V
    z5-4 (TRQV) - z5-6 (TRQG)
    Always
    8.5 to 10.5 V



NG
REPLACE STEERING COLUMN ASSEMBLY (Click here)
OK

REPLACE POWER STEERING ECU (Click here)