DTC C1552 PIG Power Supply Voltage Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1552 | PIG power source circuit malfunction inside ECU |
|

| 1.READ VALUE USING TECHSTREAM (PIG POWER SUPPLY) |
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Chassis / EMPS / Data List.
Select the item "PIG Power Supply" in the Data List and read the value displayed on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| PIG Power Supply | PIG power supply: Min.: 0 V Max.: 20.1531 V | 11 to 14 V | Power steering is in operation |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the connector from the power steering ECU.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D5-1 (PIG) - Body ground | Power switch on (IG) | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D5-2 (PGND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||