DTC C1524 Motor Circuit Malfunction |
DTC C1555 Motor Relay Welding Failure |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1524 | Short (or open) in motor circuit or abnormal voltage or current in motor circuit |
|
| C1555 | Motor relay circuit malfunction | Power Steering ECU |

| 1.READ VALUE USING TECHSTREAM (MOTOR VOLTAGE) |
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Chassis / EMPS / Data List.
Select the items "Motor Terminal Volt(U)", "Motor Terminal Volt(V)", "Motor Terminal Volt(W)" in the Data List and read the value displayed on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Motor Terminal Volt(U) | Motor terminal voltage (U phase): Min.: 0 V Max.: 46.667 V | When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed. | Engine running and steering wheel is turned |
| Motor Terminal Volt(V) | Motor terminal voltage (V phase): Min.: 0 V Max.: 46.667 V | When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed. | Engine running and steering wheel is turned |
| Motor Terminal Volt(W) | Motor terminal voltage (W phase): Min.: 0 V Max.: 46.667 V | When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed. | Engine running and steering wheel is turned |
| Result | Proceed to |
| When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed. | A |
| When the steering wheel is turned, a value other than the above is displayed. | B |
|
| ||||
| A | ||
| ||